Moves a folder along with all its sub-folders and files. It can also rename a folder.
FileMoveDir, Source, Dest , OverwriteOrRename
Name of the source directory (with no trailing backslash), which is assumed to be in %A_WorkingDir% if an absolute path isn't specified. For example: C:\My Folder
The new path and name of the directory (with no trailing baskslash), which is assumed to be in %A_WorkingDir% if an absolute path isn't specified. For example: D:\My Folder.
Note: Dest is the actual path and name that the directory will have after it is moved; it is not the directory into which Source is moved (except for the known limitation mentioned below).
This parameter specifies whether to overwrite or rename existing files. If omitted, it defaults to 0 (no overwriting and no renaming). Otherwise, specify one of the following values:
0: Do not overwrite existing files. The operation will fail if Dest already exists as a file or directory.
1: Overwrite existing files. However, any files or subfolders inside Dest that do not have a counterpart in Source will not be deleted. Known limitation: If Dest already exists as a folder and it is on the same volume as Source, Source will be moved into it rather than overwriting it. To avoid this, see the next option.
2: The same as mode 1 above except that the limitation is absent.
R: Rename the directory rather than moving it. Although renaming normally has the same effect as moving, it is helpful in cases where you want "all or none" behavior; that is, when you don't want the operation to be only partially successful when Source or one of its files is locked (in use). Although this method cannot move Source onto a different volume, it can move it to any other directory on its own volume. The operation will fail if Dest already exists as a file or directory.
[v1.1.04+]: This command is able to throw an exception on failure. For more information, see Runtime Errors.
ErrorLevel is set to 1 if there was a problem or 0 otherwise.
FileMoveDir moves a single folder to a new location. To instead move the contents of a folder (all its files and subfolders), see the examples section of FileMove.
If the source and destination are on different volumes or UNC paths, a copy/delete operation will be performed rather than a move.
FileCopyDir, FileCopy, FileMove, FileDelete, File-loops, FileSelectFolder, SplitPath