yes i have read all the compile guide , both old one and new one, as well as watched both YouTube video's one hour long each.
Many things were going over my head.
Also i read all the comments in that section.
i became confused because the compilation didnt showed any warning when i 1st compiled it. i did it as a trial run with changing the password by replacing letters of "AUTOHOTKEY"
i did the same procedure again second time with the password i wish to use and these warnings showed up.
So i downloaded the source file again from the same guide
https://www.autohotkey.com/boards/viewtopic.php?f=65&t=62308
and tried again , without even changing anything , then also these warnings showed up.
more or less i did 10+ trial and error compilation with different combination of passwords
the executable created with warnings was usable but i did notice a change in the file size.
i remember reading the same question of difference btw autohotkeysc.bin and autohotkey.exe in that section.
but when looked at the ahk2exe code i saw this, commented out
Code: Select all
; else If (UseEncrypt && SubStr(BinFile,-3)!=".bin")
; {
; if !CLIMode
; MsgBox, 64, Ahk2Exe, Resulting exe will not be protected properly, use AutoHotkeySC.bin file to have more secure protection.
; else
; FileAppend, Warning`, Resulting exe will not be protected properly`, use AutoHotkeySC.bin file to have more secure protection.: %ExeFile%`n, *
; }
thats why i asked again, srry about that.
i did asked about the warning not because it did showed up, but it really didn't showed up in the first run.
this is the 2nd time i think @SOTE is mistaking me for not reading , So i want to clarify ,same process and mixed results makes me confuse, So i have no other way to clarify other than requesting help here in the forum.